The output that follows was taken from a 1720 router. Some of this output might vary from yours, depending on the router model that you are using.
rommon 1 >confreg | Shows configuration summary. Step through the questions, answering defaults until you can change the console baud rate. Change it to 115200; makes transfer go faster |
Configuration Summary enabled are: load rom after netboot fails console baud: 9600 boot: image specified by the boot system commands or default to: cisco2-c1700 | |
do you wish to change the configuration? y/n [n]: y enable "diagnostic mode"? y/n [n]: n enable "use net in IP bcast address"? y/n [n]: n disable "load rom after netboot fails"? y/n [n]: n enable "use all zero broadcast"? y/n [n]: n enable "break/abort has effect"? y/n [n]: n enable "ignore system config info"? y/n [n]: n change console baud rate? y/n [n]: y enter rate: 0=9600, 1=4800, 2=1200, 3=2400 4=19200, 5=38400, 6=57600, 7=115200 [0]: 7 change the boot characteristics? y/n [n]: n | Prompts will begin to ask a series of questions that will allow you to change the config-register. Answer n to all questions except the one that asks you to change the console baud rate. For the enter rate, choose 7 because that is the number that represents a baud rate of 115200 |
Configuration Summary enabled are: load rom after netboot fails console baud: 115200 boot: image specified by the boot system commands or default to: cisco2-c1700 do you wish to change the configuration? y/n [n]: n rommon2> | After the summary is shown again, choose n to not change the configuration and go to the rommon> prompt again |
| | |
rommon 2>reset | Reloads router at new com speed. Change HyperTerminal setting to 115200 to match the router's new console setting |
| | |
| | |
Rommon 1>xmodem c1700-js-l_121-3.bin | Asking to transfer this image using Xmodem |
...<output cut>... | |
Do you wish to continue? y/n [n ]:y | Choose y to continue |
| | |
| | |
| | In HyperTerminal, go to Transfer, then Send File (see Figure 16-1). Locate the IOS file on the hard drive and click Send (see Figure 16-2) |
Router will reload when transfer is completed | |
| | |
Reset baud rate on router | |
| | |
Router(config)#line con 0 | |
Router(config-line)#speed 9600 | |
Router(config-line)#exit | HyperTerminal will stop responding. Reconnect to the router using 9600 baud, 8-N-1 |