A+ Complete Lab Manual

1.

What drive select jumper settings are available on a typical IDE hard drive?

2.

Which drive is usually installed as the master drive on the primary IDE interface?

3.

For a new hard drive, where are you likely to find the information needed to set up the CMOS?

4.

If the CMOS is set to auto-detect hard drives and the hard drive is detected with cylinders, heads, or sectors that are different from those listed on the hard drive label, what should you do?

1.

Drive select jumpers let you choose between master, slave, or cable select.

2.

The bootable hard drive is usually installed as the master hard drive on the primary IDE interface.

3.

The hard-drive information for CMOS setup is usually found on the hard drive’s label.

4.

Manually set the hard-drive values in CMOS.