AutoCAD 2004. One Step at a Time (Part 1)

2017-07-07 02:10:07

Create the drawing in Figure 6.9.1a using the following setup. Save the drawing as MyRemote in the C:\Steps\Lesson06 folder.

Figure 6.9.1a:

Layer Names	Color	Linetype
Button	62	continuous
Dim	cyan	continuous
Obj	211	continuous
Text	yellow	continuous
Toggle	blue	continuous
Up-Down	211	continuous

1.1	Lower left limits: 0,0

1.2	Upper right limits: 6,10

1.3	Architectural units

1.4	Grid: ¼"

1.5	Snap: as needed

1.6	Font: Times New Roman

1.7	Text Height: 1/8"

Set up a drawing to be used in Lesson 9. Use the following parameters:

2.1

Lower left limits: 0,0

2.2

Upper right limits: 17,11

2.3

Architectural units

2.4

Grid: ½"

2.5

Snap: ½"

Layer Names	Color	Linetype
Border	magenta	continuous
Gradient	cyan	continuous
Ruler	red	continuous
Text	yellow	continuous
Cl	blue	center

2.6

Draw a border ¼" in from the limits on all sides (16 ½" x 10 ½").

2.7

Save the drawing as MyRuler to the C:\Steps\Lesson09 folder.

Using the MyBase3 template created in Lesson 1 (or the Base3 template in the Lesson01 folder), create the next three drawings (Figures 6.9.3a, 6.9.3b, and 6.9.3c). Save the drawings to the C:\Steps\Lesson06 folder using the name indicated in the title block of each. All drawings use the layers indicated in the Layers 1 drawing. (Hint: Change the snap setting as needed.)

Figure 6.9.3a:

Figure 6.9.3b:

Figure 6.9.3c:

Using what you know, create the drawings in Figures 6.9.4a through 6.9.4e. The grid on each, when shown, is ¼".

Figure 6.9.4a:

Figure 6.9.4b:

Figure 6.9.4c:

Figure 6.9.4d:

Figure 6.9.4e:

Create the drawing in Figure 6.9.5a. The grid is 2". Use specific layers for each type of object being drawn.

Figure 6.9.5a:

Категории

Search