Answers to the review questions can be found in Appendix A, "Answers to Review Questions."
| 1: | What is dynamic mapping? |
| 2: | For Router-frame, map the IP address 10.0.0.1 to DLCI = 100, using the IETF encapsulation. |
| 3: | Can you use IP unnumbered with Frame Relay? |
| 4: | Can you ping your own interface address? Can you ping one spoke router from another? |
| 5: | What happens to deleted subinterfaces? |
| 6: | In point-to-point configurations that are running EIGRP, type the command for Router-frame that prevents all routing updates for interface Serial3/0:0.64? |
| 7: | Configure the Frame Relay broadcast queue for Router-framesubinterface S3/0:0.71 with queue size 100, byte rate 1200, and packet rate 120. |
| 8: | Can you configure the Cisco router as a DCE? |
| 9: | Under the interface Serial3/0:0.200, what is the backup delay command with enable delay = 5 seconds and disable delay = 10 seconds? |
| 10: | For Router-frame and interface Serial1, what is the command for TCP header compression, which is active only for the destinations that are sending compressed headers? |
| 11: | For Router-frame and interface Serial4/2:0.200, define that FRF9 payload compression will be performed on CSA 3. |
| 12: | Enable the multicast routing in Router-frame. |
| 13: | In Router-frame, for interface Serial4/2:0.100, define the upper limit of the rate for traffic shaping to 128000. |
| 14: | What Frame Relay timer defines the Cisco autosense feature? How do you configure it? |