Answers to the review questions can be found in Appendix A, "Answers to Review Questions."
| 1: | What are the first three steps to check if the user never receives an Authenticating User prompt during the initial dialer connection attempt in the VPN software client? |
| 2: | What is the CVPND event class and what is its purpose? |
| 3: | Name the main severity categories in the Cisco VPN concentrator? |
| 4: | In a 3002 HW VPN client, the user is authenticated but cannot pass any data. What are two possible reasons? |
| 5: | Which severity level events are displayed by default on the VPN HW 3002 client? |
| 6: | How do you proceed if a NAT/PAT configuration already exists in the router and you are about to configure an Easy VPN client? |
| 7: | What is the command for the Easy VPN client to reset the VPN connection? |
| 8: | What is the command for Easy VPN to check the status of the Cisco Easy VPN client profile? |
| 9: | To verify the applied policy in Cisco Easy VPN, what command do you use? |
| 10: | In the PIX-based VPN client, how do you verify if the VPN client is active? |
| 11: | In the PIX-based VPN client, how do you check that the VPN tunnel has been established? |
| 12: | What are two debug commands to debug the PIX-based VPN establishment of IPSec and ISAKMP? |
| 13: | What parameters define the PPPoE session uniquely? |
| 14: | Name the modulation techniques for the DOCSIS 2.0 standard. |
| 15: | If the TCP protocol is notified for packet loss, how does it react? |