Performing Transactions Using SQL
15.3.1 Problem
You need to issue a set of queries that must succeed or fail as a unit.
15.3.2 Solution
Manipulate MySQL's auto-commit mode to allow multiple-statement transactions, then commit or roll back the statements depending on whether they succeed or fail.
15.3.3 Discussion
This section describes the SQL statements that control transactional behavior in MySQL. The immediately following sections discuss how to perform transactions from within programs. Some APIs require that you implement transactions by issuing the SQL statements discussed in this section; others provide a special mechanism that allows transaction management without writing SQL directly. However, even in the latter case, the API mechanism will map program operations onto transactional SQL statements, so reading this section will give you a better understanding of what the API is doing on your behalf.
MySQL normally operates in auto-commit mode, which commits the effect of each statement as it executes. (In effect, each statement is its own transaction.) To perform a multiple-statement transaction, you must disable auto-commit mode, issue the statements that make up the transaction, and then either commit or roll back your changes. In MySQL, you can do this two ways:
- Issue a BEGIN (or BEGIN WORK) statement to suspend auto-commit mode, then issue the queries that make up the transaction. If the queries succeed, record their effect in the database and terminate the transaction by issuing a COMMIT statement:
mysql> CREATE TABLE t (i INT) TYPE = InnoDB; mysql> BEGIN; mysql> INSERT INTO t (i) VALUES(1); mysql> INSERT INTO t (i) VALUES(2); mysql> COMMIT; mysql> SELECT * FROM t; +------+ | i | +------+ | 1 | | 2 | +------+
If an error occurs, don't use COMMIT. Instead, cancel the transaction by issuing a ROLLBACK statement. In the following example, t remains empty after the transaction because the effects of the INSERT statements are rolled back:
mysql> CREATE TABLE t (i INT) TYPE = InnoDB; mysql> BEGIN; mysql> INSERT INTO t (i) VALUES(1); mysql> INSERT INTO t (x) VALUES(2); ERROR 1054 at line 5: Unknown column 'x' in 'field list' mysql> ROLLBACK; mysql> SELECT * FROM t; Empty set (0.00 sec)
- Another way to group statements is to turn off auto-commit mode explicitly. Then each statement you issue becomes part of the current transaction. To end the transaction and begin the next one, issue a COMMIT or ROLLBACK statement:
mysql> CREATE TABLE t (i INT) TYPE = InnoDB; mysql> SET AUTOCOMMIT = 0; mysql> INSERT INTO t (i) VALUES(1); mysql> INSERT INTO t (i) VALUES(2); mysql> COMMIT; mysql> SELECT * FROM t; +------+ | i | +------+ | 1 | | 2 | +------+
To turn auto-commit mode back on, use this statement:
mysql> SET AUTOCOMMIT = 1;