Implementing Advanced AToM Features
Review Questions
| 1 |
Which protocol is used for AToM pseudowire control channel signaling? |
| 2 |
What are the three steps of AToM pseudowire setup between peer PE routers (assuming an LDP session has not yet been established between PE routers)? |
| 3 |
An AToM data channel packet typically consists of which elements? |
| 4 |
Can TDP be used to signal the tunnel LSP? Can TDP be used to signal AToMPW/VC labels? |
| 5 |
If an AToM HDLC pseudowire is used to transport Frame Relay (Frame Relay port mode), in what way do PE routers participate in LMI? |
| 6 |
How can Layer 2 traffic to be forwarded between attachment circuits on the same PE router? |
| 7 |
What is one method of configuring RVSP-TE signaled tunnel LSPs to transport AToM pseudowires between PE routers? |
| 8 |
When transporting ATM cells over an AToM cell relay pseudowire, how is it possible to transport more than one ATM cell per AToM data channel packet? |
| 9 |
How is it possible to connect dissimilar attachment circuit types over AToM pseudowires? |
| 10 |
What are the two modes of L2VPN interworking? |